2-Layer Through-Hole PCB Layout

The schematic for my project is finished; what I need now is a clean, production-ready two-layer PCB designed in Altium. Every component on the board is through-hole, so pad sizes, hole diameters, annular rings and keep-outs must favour easy hand-soldering while still meeting modern fabrication standards. I do not yet have a specific manufacturer in mind, so I will rely on you to recommend practical design-for-manufacture rules (trace widths, clearances, drill limitations, etc.) that suit common low-volume board houses. Please fold those constraints into the layout from the start rather than treating them as a post-process check. Good thermal relief on large copper areas, sensible power/ground routing, and a tidy silkscreen with readable reference designators are essential for inspection and rework later. Send back the board ready for ordering and assembly: • Altium project files fully editable • Fabrication outputs (Gerber, NC Drill, solder mask) generated from the same revision • Pick-and-place file and updated BOM that reflects any footprint or part-number changes Before placement begins I will provide the schematic PDF, the netlist, the mechanical outline of the enclosure, and any part datasheets you request. A quick review and confirmation that nothing is missing will kick off the job.