Renesas MCU IEC104 TCP/IP Firmware using quectel

I need production-ready firmware for a Renesas MCU that will exchange data through a Quectel EC200 cellular module using both IEC 60870-5-104 and plain TCP/IP protocols. The code must handle complete data transmission, reception, and on-board processing so the MCU can act as an intelligent field unit that talks reliably to a SCADA master as well as to standard IP services. Scope • Build or integrate a lightweight IEC104 stack alongside a TCP socket layer that can coexist without blocking. • Manage all EC200 interactions (AT commands, connection setup, keep-alive, error recovery) over UART/SPI as appropriate. • Implement configurable buffers, parsing, and frame validation so that raw sensor payloads can be wrapped/unwrapped for each protocol. • Provide hooks where my application code can push outgoing payloads and consume validated incoming data. • Deliver clean, well-commented Embedded-C (or C++) project targeted to Renesas e² studio or similar, plus a brief user guide and test scripts. Acceptance criteria 1. Demo build loads on the target Renesas board and opens both protocol sessions concurrently. 2. Test bench proves 100 % successful transmit/receive cycles for at least 24 h with no memory leaks. 3. Code passes MISRA-C basic checks and compiles with zero warnings at high warning level. 4. Handoff includes full source, linker files, and step-by-step build instructions. Please attach a detailed project proposal outlining architecture choices, libraries you plan to use (commercial or open-source), estimated timeline, and your test plan.