arrow_back Back to freelances
F

KiCad ESP32 PCB

Freelancer

Share:
placeCH home_workRemote assignmentContract publicAggregated job · CH

eventPublished on Nov 18, 2026 · verifiedWe confirmed on Nov 18, 2026 that it's still live

Is this your business?

US$ 30 – US$ 250 per project

About the job

KiCad PCB design – ESP32-S3 battery-powered device (schematic review + layout) Project: Round PCB (approx. Ø74 mm) for a waterproof device. 1-cell Li-ion 21700 (6 Ah), 3 A USB-C charger (BQ25895), cell protection (BQ29700 + dual MOSFET), fuel gauge (MAX17048), 3.3 V buck-boost, 5 V boost for a laser TOF sensor, ESP32-S3-WROOM-1 (antenna on module or uFl antenna), 24 addressable LEDs (SK6812MINI), push button. Available: KiCad schematic (v0.4, ERC clean), BOM with footprints, 3D enclosure (STEP) with all mechanical constraints. Scope: Review the schematic and propose fixes (power, protection, USB-C, ESP32 boot/USB). Finalise the open parts (USB-C waterproof receptacle, battery clip footprint). Board outline from the STEP file, placement respecting the enclosure (battery clips, TOF sensor, USB-C, antenna keep-out). Routing (2 or 4 layers, your recommendation), DRC clean. Fabrication outputs for JLCPCB assembly: Gerbers, BOM, CPL.

Requirements

KiCad 8 or 9. Experience with ESP32 RF layout, switching regulators and Li-ion charging/protection. All source files and IP transferred to the client.

Keep reading for free

Create a free account to see the full job and apply.

  • badgePortfolio visible to companies
  • notificationsNew job alert by email
  • favoriteFree subscription, cancel at any time